Tektronix KEITHLEY 707B, Reference Manual

Page: 406 / 534

Models 707B and 708B Switching Matrix Reference Manual Section 7: TSP command reference
707B-901-01 Rev. B / January 2015 7-175
For information about .condition, .enable, .event, .ntr, and .ptr registers, refer to Status register set
contents (on page C-1) and Enable and transition registers (on page C-20). The individual bits of this
register are defined in the following table.
Bit Value Description
B0 status.MEASUREMENT_SUMMARY_BIT
status.MSB
Set summary bit indicates that an enabled measurement
event has occurred.
Bit B0 decimal value: 1
B1 Not used Not applicable.
B2 status.ERROR_AVAILABLE
status.EAV
Set summary bit indicates that an error or status
message is present in the Error Queue.
Bit B2 decimal value: 4
B3 status.QUESTIONABLE_SUMMARY_BIT
status.QSB
Set summary bit indicates that an enabled questionable
event has occurred.
Bit B3 decimal value: 8
B4 status.MESSAGE_AVAILABLE
status.MAV
Set summary bit indicates that a response message is
present in the Output Queue.
Bit B4 decimal value: 16
B5 status.EVENT_SUMMARY_BIT
status.ESB
Set summary bit indicates that an enabled standard
event has occurred.
Bit B5 decimal value: 32
B6 status.MASTER_SUMMARY_STATUS
status.MSS
Set bit indicates that an enabled Master Summary
Status (MSS) bit of the Status Byte Register is set.
Bit B6 decimal value: 64
B7 status.OPERATION_SUMMARY_BIT
status.OSB
Set summary bit indicates that an enabled operation
event has occurred.
Bit B7 decimal value: 128
As an example, to set the B0 bit of the system node enable register, set
status.node_enable =
status.MSB
.
In addition to the above values,
nodeEnableRegister
can be set to the numeric equivalent of the
bit to set. To set more than one bit of the register, set
nodeEnableRegister
to the sum of their
decimal weights. For example, to set bits B0 and B7, set
nodeEnableRegister
to 129 (1 + 128).
Bit B7 B6 B5 B4 B3 B2 B1 B0
Binary value 0/1 0/1 0/1 0/1 0/1 0/1 0/1 0/1
Decimal 128 64 32 16 8 4 2 1
Weights
(2
7
) (2
6
) (2
5
) (2
4
) (2
3
) (2
2
) (2
1
) (2
0
)
Example 1
nodeEnableRegister = status.MSB + status.OSB
status.node_enable = nodeEnableRegister
Sets the MSB and OSB bits of the
system node enable register using
constants.
Example 2
-- decimal 129 = binary 10000001
nodeEnableRegister = 129
status.node_enable = nodeEnableRegister
Sets the MSB and OSB bits of the
system node enable register using a
decimal value.
Also see
status.condition (on page 7-172)
status.system.* (on page 7-190)
Status byte and service request (SRQ) (on page C-16)