Tektronix GeoProbe G10, Installation Manual

Page: 64 / 168

G10 Installation Guide 7.13.2 64

4
Power On G10 and Configure Network Connectivity Rev. 005-140228
4. Perform one of the following:

DC Units: Verify that the green IN LED is ON and that the REVERSE LED
is OFF.
- If the green IN LED is OFF or the red REVERSE LED is ON, refer to
Table C.1 on page 112 before proceeding.
- If the green IN LED is ON, press the ON/OFF switch to the ON position on
both PEMs on the front of the G10 chassis ( Figure 4.3 ). The
BACKPLANE LEDs will illuminate green indicating the PEM is sending
power through the backplane.

AC Units: Connect the AC power cables into the rack power outlets. Verify
that the STATUS LED is GREEN.
- If the STATUS LED is not green, refer to Table C.2 on page 114
before proceeding.
Figure 4.3 - G10 DC and AC PEM Front Panels
5. Verify the following LEDs on the front of the IIC ( Figure 4.4 ):

The + LED on the IIC100/IIC200 is OFF, indicating no errors in overall
health of the IIC.
IN LED BACKPLANE LED
ON/OFF Switch
DC PEM
STATUS
LED
AC PEM
REVERSE
LED
Tektronix Communications | For Licensed Users | Unauthorized Duplication and Distribution Prohibited