G10 Installation Guide 7.13.2
130
C
Rev. 005-140228
Removing or Resetting the IIC100 or IIC200
Perform the following to reset or remove the IIC.
Step
Action
1.
Rotate the IIC’s right ejector handle outward as shown in (
Figure C.22
).
Figure C.22 - IIC Right Ejector Handle
2.
Push and
hold
the ejector handle in the forward position and then rotate it
outward slightly until it cannot rotate any farther (
Figure C.23
). The blue Hot
Swap LED starts to blink, indicating that the blade is shutting down the OS.
Figure C.23 - IIC Right Ejector Handle Hot Swap Positioning
Hold Ejector Handle in
Forward Position
Swing Handle Outward
Slightly
Ejector Handle
Start Position
Tektronix Communications | For Licensed Users | Unauthorized Duplication and Distribution Prohibited
