Tektronix 6 series, Printable Help

Page: 284 / 518

Other search types.
Bus Search configuration menus on page 230
Edge Search configuration menu on page 250
Logic search configuration menu on page 251
Pulse Width Search configuration menu on page 253
Rise/Fall Time Search configuration menu on page 255
Runt Search configuration menu on page 257
Setup and Hold Search configuration menu on page 258
Timeout Search configuration menu on page 260
Analog Channel configuration menu
Use the Analog Channel configuration menu to set up analog channel vertical settings, probe settings, deskew settings, external
attenuation, and alternate units for analog channel inputs.
To open an analog Channel configuration menu, double-tap an analog Channel badge. The following text describes analog
channel settings. For digital channel settings, see
Digital channel configuration menu on page 274.
Vertical Settings panel, fields and controls
Field or control Description
Display Tap to toggle display of the channel On and Off.
Vertical Scale Tap to set the scale using the multipurpose knob, double-tap to bring up the virtual keypad, or
tap the up and down arrows to change the scale.
Offset Double-tap the field to set the offset using the virtual keypad.
Set to 0 Tap to set the offset to 0.
Position
Double-tap the field to set the vertical position using the virtual keypad.
Set to 0 Tap to set the waveform zero volt level to the center of the slice or waveform view.
Label Double-tap the field to add a label to the channel display using the virtual keypad.
Coupling Tap to set the input coupling to DC or AC.
Termination Tap to set the input termination to 1 MΩ or 50 Ω. If you are using a supported TekVPI probe,
this value is automatically set by the probe and these controls are not available.
Menus and dialog boxes
264 MSO54, MSO56, MSO58, MSO58LP, MSO64 Help