Tegam 2411B, Operation Manual

Page: 65 / 140

Chapter 5 Multi-Instrument Operation
Multiple Phase Operation (continued)
Multiple Phase Operation (continued)
Case 3 -- Trigger-Sequential
This is a special case of TRIG mode which allows you to output the signal from each unit sequentially.
Both units are in TRIG mode. Upon receiving the trigger signal (external or manual), the master unit
starts to run while the slave unit waits to receive the SYNC TRIG pulse from the master unit. Upon
receiving the pulse, the slave unit runs for one cycle and stops. If the feedback connection is
made from the SYNC TRIG OUT of the slave unit to the TRIG IN of the master unit, then you can cre-
ate the configuration which indefinetely outputs the signal from each unit upon completion of the other
unit. m this case, you must start the master unit by pressing the manual TRIG button (SHIFT-0) on the
front panel.
5-5