Chapter 1 Quick Start
To select a operating mode
To select operating mode
The following steps will show you how to select an operating mode and output one cycle of a sinewave-
when a trigger signal is applied. The 2411B is initially set to
CONT
(continuous) mode.
1. Select a standard waveform.
See page 1-7 for the procedure.
2. Press MODE key to change the operating mode.
Press
TRIG
(F2 soft key) to select trigger mode.
3. Press ENTER button to select the mode.
Whenever an asterisk is displayed on the LCD screen, the parameter selection is pending. You must
press
ENTER
button to complete the selection.
4. Press SHIFT button and then press TRIG button (number 0 on 10-key) to output a single cycle
of a sinewave.
Please note the LED light will turn on when
SHIFT
button is pressed. While the
SHIFT
light is on, the
keypad will not function as a 10-keypad. Press again to disable the SHIFT button.
Note:
If you apply a single trigger pulse to the
TRIG IN
(TTL level) on the rear BNC connector, you can also
output a single cycle of a sinewave.
By selecting
UTIL
(UTILITY) button and then selecting
TGEN
(
T
rigger
GEN
erator) (F4), you may
activate the internal trigger generator. When the internal generator is not in use, make sure that the trig-
gert generator is set to OFF. Otherwise, it may interfere with other operation modes.
1-12
*MODE
cont TRIG gate brst
MODE:
cont TRIG gate brst
Summary of Contents for 2411B
