Tegam 2411B, Operation Manual

Page: 47 / 140

Chapter 4 Waveform Creation System
Waveform Creation using Front Panel-Line Mode
Line Mode (continued)
LCD. Use edit knob or keypad to select X address for the end of the
edited portion of the waveform.
9) Press OK (F3) to store right anchor or CANC (F4) to cancel.
Editing From Left Anchor
1) Press EDIT key.
2) Press LINE softkey (Fl).
3) Select Waveform Number using edit knob or keypad (press ENTER after using keypad).
4) Arbitrary waveform construction can begin at any X address within the selected waveform num-
ber block. Press ANCH soft key (F2). (If the Start Point is to be uniquely defined, see previous
section.)
5) Use double-arrow key to move Left Anchor ( AL ) to right side of display. Use edit knob or key-
pad to select X address. (Remember to press ENTER if keypad is used.)
6) Use double-arrow key to move Right Anchor ( AR ) to right side of LCD. Use edit knob or key-
pad to select X address for the end of the edited portion of the waveform.
7) Press OK (F3) to store anchors or CANC (F4) to cancel.
Creating Line Segments
1) Press CHRD (chord) softkey (F3). (Set anchors first per previous section.)
2) Use edit knob, keypad or optional mouse to select X and Y addresses for the destination of the
first line segment (chord). If the mouse is used, LCD readouts will continually indicate mouse
position.
3) When the desired position is reached, press OK (F3) and the line segment will be stored. Press
CANC (F4) to cancel.
4) Create the next line segment by again using the knob or keypad to set the next X-Y coordinate,
as before.
5) Continue adding line segments up to the limit established in step 5 of Editing from Start Point
section.
4-7