Chapter 4 Waveform Creation System
Waveform Creation using Front Panel-Vertex Mode
Vertex Mode (continued)
NOTE
The digital amplitude default value is 65535. The
available range of settings is ±131071. A negative
setting inverts the edited waveform portion. Re-
scaling amplitude from the default value of 65535
to the maximum value of 131071 doubles the output
amplitude. Steps 1-4 above can be repeated as
necessary to enlarge small signals.
CAUTION
The waveform will be clipped if the scaling factors
exceed the 65535 points available in the waveform
memory.
Smoothing
A smoothing factor may be applied to any part or all of a waveform. It is computed as a moving average
over a specified number of samples.
1) Select anchors as in
Selecting Left and Right Anchor Points
section.
2) Press either the left or right arrow key.
3) Press
SMOO
softkey (F3).
4) Select the number of samples to be averaged (up to 250) using the edit knob or keypad.
5) Press
SHOW
softkey (F2) to preview.
6) Press
CANC
softkey (F4) to cancel.
7) Press
OK
softkey (F3) to store smoothed waveform.
Inserting Standard Functions
Any one of 20 standard functions can be inserted between the left and right anchors.
1) Select anchors as in
Selecting Left and Right Anchor Points
section.
2) Press
INSF
softkey (F4).
3) Select desired standard waveshape by pressing softkey. Use left and right arrow keys to view
all 20 waveshapes. Access any desired ancillary functions by pressing the right arrow (->)
softkey (Fl).
4) Press
SHOW
softkey ( F2) to preview selection.
5) Press
CANC
softkey (F4) to cancel selection.
6) Press
OK
softkey (F3) to store selection.
4-11
Summary of Contents for 2411B
