Chapter 8 Advanced Remote Operation
Waveform Editing Principles
Waveform Editing Principles (continued)
The minimum and maximum y values for the two memories are -32768 and +32767, respectively.
When using the Waveform editing commands to operate on a specific waveform memory, it is important
to realize that these commands only effect the active area (See Note below), hi other words, if you want-
ed to create a sinewave with three cycles, starting at 0 phase, you would send the following command:
WVFM:SINE 3,0;:EXEC
This command would place three cycles of sinewaves into the active area, with a maximum and mini-
mum y value the same as the active area. The commands LEN, MINY, MAXY, and POSN all affect the
actual dimensions of the active area as follows:
LEN - The length command determines the actual horizontal length of the active area. This
maximum length is SIZE-POSN.
MINY
- The minimum y command sets the lowest y value for the active area.
MAXY - The maximum y command sets the highest y value for the active area.
POSN - The position command determines the horizontal starting point for the active area.
Note that once a waveform is written into the active area (using the waveform edit
commands), POSN is changed to the point POSN + LEN.
Important Note:
For the Standard Waveform (STDW), the active area is always the entire area defined
by SIZE. Thus, none of the four commands mentioned above effect the STDW.
8-20
Summary of Contents for 2411B
