Tegam 2411B, Operation Manual

Page: 45 / 140

Chapter 4 Waveform Creation System
Memory Organization-Waveform Number Block Lengths (continued)
Memory Organization-Changing Waveform Block Length (continued)
1) Press SETUP key.
2) Press STDW softkey (F2). The display indicates the present length of the standard wave and
the address where it begins in memory.
3) Press LEN softkey (F4). The display indicates the available free memory.
4) Select desired standard wave length with edit knob or keypad. (Do not attempt to exceed the
amount of memory available.)
5) Press OK (F3) to enter change or CANC (F4) to cancel.
6) Press ENTER .
Waveform Number Block Length
The waveform length of the numbered blocks can be changed from their default values of 2000
points. (Minimum waveform length is 32 points.)
1) Press
SETUP key.
2) Press WAV# softkey (Fl).
3) Select Waveform Number with edit knob. The display indicates the present length and start
address of the waveform.
4) Press LEN softkey. The display indicates the available free memory.
5) Select desired waveform block length with edit knob or keypad. (Do not attempt to exceed
the amount of memory available.)
6) Press OK to enter change or CANC to cancel.
Deleting Waveform
A waveform which is no longer needed can be deleted from memory as follows:
1) Press SETUP key.
2) Press WAV# softkey.
3) Select Waveform Number with edit knob.
4) Press
DEL softkey.
5) Press OK to delete or CANC to cancel.
Inserting New Waveform Numbers
Unused Waveform Numbers can be activated as follows:
1) Press SETUP key.
2) Press WAV# softkey.
3) Press NEW softkey.
4) Screen will show all unused Waveform Numbers when edit knob is turned. Select desired
number.
5) Move waveform length to right side of display with double-arrow key and set desired length
with edit knob or keypad.
(New waveform cannot be longer than available free memory.)
6) Press OK to insert new Waveform Number or CANC to cancel.
4-5