Tegam 2411B, Operation Manual

Page: 77 / 140

Chapter 7 Remote Interface Operation
Command Features (continued)
Command Features (continued)
Waveform Selection
Waveform selection takes two steps to complete the process.
1) Select one of the three types of function; standard wave (STDW), user-defined wave (WAVE) and
sequence (SEQ). You can only point to the type and the waveform and sequence number. You can not
select the content of the standard wave but you will get the last standard waveform selected.
2) Select one of the standard waveform from the waveform (WVFM) command.
To select a type of waveform, use FUNCTION (FUNC) command.
:FUNCTION WAVE,12;:EXEC --- select user-defined waveform #12
:FUNCTION WAVE,STDW;:EXEC --- select standard waveform
:FUNCTION SEQ,10;:EXEC --- select sequence waveform #10
A space is required after the command headers.
To select a standard waveform
:WVFM:SINE;:FUNC WAVE,STDW;:EXEC --- select sinewave.
Select sine wave as Standard Wave.
Waveform Deletion
There are no delete command for waveforms or sequences. In all cases, to delete an item you must set it
to zero.
To delete a user-defined waveform, set the size to zero (0).
:WVFM:WAVE 10;SIZE 0 --- delete WAVE#10
The size is set to zero.
To delete a sequence, send the sequence number which you want to delete and eliminate the step data.
: WVFM: SEQ 12 --- delete SEQ#12 if it exists.
To delete a step in a sequence, set the repeat to zero (0).
:WVFM:ADDSEQ 12,1,0,5 -- delete SEQ#12 Step#5
STEP#
The repeat is set to zero.
WAVE#
SEQ#
7-6