1
1.C
1.B
5
Connect
CONN. 3
the other connectors
(
)
2
3
2
Press
CONN 1
the programming switch while
inserting the main wires harness (
)
into the CAN-VSS module.
The LED will illuminate to indicate you are in
programming mode, release the
programming button.
IGN
START
OFF
3
IGN
START
OFF
Turn the key to the
.
"ON" position
The LED will flash until you
.
The LED will turn off to indicate the
module has been programmed.
press the
OEM remote lock button
The module is now ready for use.
Once the LED starts to flash rapidly
turn the key to the
.
The LED will turn off to indicate the
module has been programmed.
(* Except chrysler, Dodge, Jeep
models do step 7)
OFF position
The module is now ready for use.
Connector 3 (White, located at the back of the module):
Make the connections associated with the vehicle in the
VEHICLE FIT GUIDE (P.2)
For Chrysler/Dodge/Jeep models
1.A
Connector 2 (White):
Make the connections associated with the vehicle in the
VEHICLE FIT GUIDE (P.2)
6
4
1
Make the connections of the CAN-VSS to the
vehicle:
Connect
CONN. 2
the other connectors
(
)
*
7
PANIC
LOCK
UNLOCK
UNLOCK
3
VSS SIGNAL GENERATOR USING CAN PROTOCOLS
CAN-VSS
(CAN SW) Data
(CAN Low) Data
Brown
Grey/Black
Grey
Brown/White
1
2
12V Battery
(+)
Ground
(-)
Red
Black
Blue
White
LED
Programming
Button
Connect wire to vehicle
Connect wire to the cruise control or GPS system
INPUT
OUTPUT
conn.
conn.
conn.
4
1
4
1
P.1
TECHNICAL SUPPORT / INFORMATION
TECHNICAL SUPPORT / INFORMATION
P.1
Neither the manufacturer or distributor of this module is
responsible of damages of any kind indirectly or directly
caused by this module, except for the replacement of this
module in case of manufacturing defects. This module must
be install by qualified technician. This instruction guide may
change without notice.
isite www.ifar.ca to get latest
version.
V
START HERE
INSTALLATION AND PROGRAMMING INSTRUCTIONS
INSTALLATION AND PROGRAMMING INSTRUCTIONS
Front view of the module
WIRING / CONNECTION GUIDE
WIRING / CONNECTION GUIDE
See wiring schematic configuration
Back view of the module
(CAN High) Data
Yellow
Purple
Orange
Blue
Pink
VSS
White
Lt. Blue
Yellow/Black
Ignition
Purple/Black or Purple/White
14
8
1
7
Orange/Black
Green
Pink/Black
White/Black
Lt. Blue/Black
Tach
~
~
Technical support:
Web: www.ifar.ca
TEL: 514-255-2720
FAX: 514-255-1367
INSTALLATION GUIDE
Made in Canada - V1.0.c - October 26, 2006
W e b
s i t e :
h t t p : / / w w w . i f a r . c a
N.C.
N.C.
N.C.
N.C.
N.C.
N.C.
N.C.
N.C.
N.C.
N.C.
N.C.
N.C.
N.C.
N.C.
Connector 1 (Black):
Cut off one plug of the Data-Link connector.
Connect the red wire to +12V,
Connect the black wire to GROUND.
Copyright © 2006, FORTIN AUTO RADIO INC
ALL RIGHTS RESERVED
