Technogym EXCITE Run 500, Service Maintenance Manual

Page: 146 / 234

RUN EXCITE-2008: Service & Maintenance Manual - rev. 1.3
Page 7.38
Figure7.21-11
13. Back off the 2 screws
(i)
with a 5mm
hexagonal wrench and remove the running
deck stops.
14.
Remove the running deck.
ATTENTION: During reassembly, lock
down the screws (i) using torque wrench
set for 9 Nm.
Figure 7.21-12
15. Back completely off the bolts which are
fixing the rear roller on the frame.
16.
Remove the rear roller as indicated by with
arrows.
17.
Remove the belt.
ATTENTION: When reassemble the
tread belt pay attention to put it on in
correctly, because it can not turn in the
wrong way. Check that the arrow
marked inside on the tread belt junction
is facing backside (when the junction is
above the running deck).
ATTENTION: At the end of the
procedure, check the alignment of the
motor drive-belt, the tension and
alignment of the tread belt and the
height adjustment of the running deck,
carry out the procedure as described at
the paragraph: 8.1. “Trade belt
tensioning”, 8.2. “Centering the tread
belt” and 8.3. “Aligning the tread-belt
motor drive-belt”.
Continued on following page
→