Technogym EXCITE Run 500, Service Maintenance Manual

Page: 101 / 234

RUN EXCITE-2008: Service & Maintenance Manual - rev. 1.3
Page 6.37
Follow the procedure step by step to correctly diagnose the problem. Take particular care with the
checks highlighted by circled numbers, which are described in detail below:
(1) Place the tester probes across pins 1 and 8 of connector CN1 of CU132 cable of the TGS
reader. The measured value should be +12 Vdc.
(2) As for step (1) but across pins 1 and 9 of connector CN7 of TRM32 cable on the display
board.
(3) Use the serial communications test described at paragraph: 6.2.1.5 “ Serial Ports Test ”.
If you replace Display board/Brake board, check that its SW version is updated,
otherwise install the last version.