Teac DS Series, Instruction Manual, Page: 36 / 104

Page 28
6.5 Record Mode Setting
You can set the recording mode. You can select a mode to stop recording at media full or an
endless mode by using the internal HDD as a ring format to continue recording until STOP
condition met.
1.
Go to the <RECORD> menu.
2.
Move the cursor to [RECORD MODE] by pressing the down keys.
3.
Press the ENTER key to go to <RECORD MODE>. The selectable record modes are
displayed.
NORMAL Stop recording at the media full state.
ENDLESS Record continuously until STOP condition is met by using the internal
HDD as a ring format. In this mode, press REC to start recording,
refer
“
7.2 Start and Stop Recording
”
.
The synchronization recording mode does not support the endless
recording.
The endless mode is effective only when the recording to the internal
hard disk is selected.
Elapsed time on the LCD returns to 00:00:00 and then counts up again
after it reaches to 9999:59:59.
4.
Press the ENTER key by moving the cursor to a desired record mode to go to the confirmation
of the current selection.
5.
Press the ENTER key to decide the selection to go to the <RECORD> menu.
If you do not want to decide the selection, press the STOP key. The selection is not effective.
Then return to the <RECORD> menu.