Teac DS Series, Instruction Manual, Page: 28 / 104

Page 20
6.1.4 Zero Shift
You can set the input zero shift value /- 120% of the input range of each channel.
1.
Move the cursor to [ZERO SHIFT] by pressing the down keys at the <INPUT AMP> menu.
2.
Press the ENTER key to got to <ZERO SHIFT>.
3.
Move the cursor to the channel to set the zero shift by pressing the up and down keys.
4.
The system outputs a signal of the cursor channel at the MON OUT connector. Press the left
or right key to specify the displayed percentage as the zero shift value by monitoring the output
signal. An example is connecting to an oscilloscope.
You can set all effective channels with the same zero shift value at [ALL]. (The system outputs
the signal of Channel 1, and displays the zero shift percentage of Channel 1.)
You cannot set the zero shift when you assign Channel 1 for the memo voice channel (refer
“6.7.1 Memo Voice Channel Setting”, <1ch MEMO> is displayed).
5.
Press the ENTER key to choose the zero shift setting on each channel to go to <INPUT AMP>.
Press the STOP key to cancel the selections and return to <INPUT AMP>.
About Zero Shift at Auto Range
Adjust the zero shift again after operating the auto range. The auto range measures the signal
by canceling the preset zero shift value.