Teac DS Series, Instruction Manual, Page: 20 / 104

Page 12
4.2 How to Move Among Menus
Press the ENTER key at the cursor position to move to the lower hierarchic menu.
At the menu displayed [<<TOP]
、
[< BACK],
press the ENTER key by locating the cursor at [<<TOP] to return to ready state (<READY>
display).
press the ENTER key by locating the cursor at [< BACK] to move the main menu.
Press the STOP key to return to each menu item without reflecting any changes.
The STOP key works to move to the upper hierarchic menu without changes.
4.3 Functions on Each Menu
The functions of each menu are explained in this paragraph.
Main Menu Menu Functions
PLAYBACK
Move to playback
menu.
You cannot operate the
menu at the unit
without playback
features.
RECORD
Settings related
“recordings”, such as
recording amps,
recording device,
sampling frequency,
and number of
channels.
INPUT AMP
SAMPLE
CHANNEL
TARGET DEVICE
RECORD MODE
TRIGGER
Set the recording amp (*1)
Set the sampling frequency.
Set the number of recording channels.
Select the target device for recording.
Select the recording mode.
Set for the trigger.
SYSTEM
Settings related
“system”, such as voice
memo recording and
speaker output, and
operations related
internal HDD.
MEMO
SPEAKER OUT
HDD CHANGE
HDD FORMAT
DEL LAST DATA
IRIG-B
Set to use Channel 1 for voice memo.
Set the output from the internal speaker.
Exchange the internal HDD.
Format the internal HDD.
Delete the last recorded file.
Set to display the time by reading the IRIG-B time
code input.
PARAMETER
Load and save the
setting parameters and
initialize the system
settings.
PARAMETER LOAD
PARAMETER SAVE
DEFAULT
Load the setting parameters saved into the DS unit.
Save the current system settings into the DS unit.
Initialize the system settings, then restart the system.
MISC
Settings for LCD
contrast, execute self
test, and display the
system information.
CONTRAST
SYS INFO
SYNC INFO
Set the LCD contrast.
Display the system information.
Display the synchronized unit information.
NETWORK
Settings related
network connections.
SET NETWORK
CHANGE PARAM
NETWORK DRIVE
Set the parameters entered at [CHANGE PARAM].
Select the network address and parameters.
Display the shared folder name of the network drive.
*1 There is a lower hierarchic sub-menu at [RECORD] [INPUT AMP]
⇒
.
INPUT AMP
Settings related
“channels” of the
recording amp, such as
input range and input
mode of each channel.
RANGE
AUTO RANGE
MODE
ZERO SHIFT
CALIBRATION
Set the input range of each channel.
Set by auto range settings.
Set the input mode of each channel.
Set the zero shift value at recording.
Execute the manual calibration to correct the offset
value and the linearity.