Teac DS Series, Instruction Manual, Page: 34 / 104

Page 26
6.4 Recording Target Device Setting
You can select the recording target device.
1.
Go to the <RECORD> menu.
2.
Move the cursor to [TARGET DEVICE] by pressing the down keys.
3.
Press the ENTER key to go to <TARGET DEVICE>.
4.
Move the cursor to the recording target device to be used with the up and down keys.
HDD Record to the internal hard disk.
LAN Record to the mounted network drive.
Both Record to the internal hard disk and the network drive at the same
time.
Recording to Network Drive
Set [Net Drive] on the network device setting by using the browser.
You cannot connect to the network drive if its remain capacity is 4GB or less.
You need an extended capacity of 5 GB or more to your expected recording amount.
When you select [LAN] or [Both] to record to the network drive, the recording may not be
continued because enough data transmission band via network is not secured. In this case,
<TOO SLOW!> is displayed and the recording is stopped right after recording start.
<TOO SLOW!> disappears when moving from the current menu.
If the network drive reaches to full while recording, the DS stops recording and displays <DSIK
FULL!!> by terminating the network connection. Secure an empty space first on the network
drive and then reconnect and set [Net Drive].
5.
For example, select [HDD]. Press the ENTER key by confirming the cursor is in [HDD].