Tandberg Data Storage Library T128, User Manual

Page: 32 / 192

20 Setting Up the Library
If you need to license additional storage slots, contact technical support for license keys to activate the
additional slots. For contact information, see
Getting More Information or Help on page 2. For
instructions on licensing storage slots, see Applying License Keys on page 43.
8 Load tape cartridges into the library.
You can use the I/E commands to import tape cartridges into the library or perform an initial bulkload of
the library.
When bulkloading the library, do not insert storage or cleaning tapes into the bottom two rows of the
lowest module in the library configuration. In any library configuration, the picker cannot access the
bottom two slots in each column in the lowest module in the stack due to the fact that there is not enough
clearance at the bottom of the library for the robotic picker.
For instructions on importing tape cartridges, see Importing Media on page 58. For information on
bulkloading, see Bulkloading on page 59. For complete installation instructions, see Installing,
Removing, and Replacing on page 83.
9 Connect to the host application .
Set up the connection to the library host application. If your host application inventories the location of
each tape cartridge in the library, open the host application and perform a reinventory to sync the logical
inventory with the physical inventory of the library.
For instructions, see your host application documentation.
10 Register the library .
For more information about registering the library, see Registering the Library on page 54.
11 Run the library.
You are now ready to start using your library. For information about using your library, see Running Your
Library on page 55 and the library’s online Help.
Downloading Drivers
You can find drivers for your library at www.tandberg.com .