Tandberg Data Storage Library T128, User Manual

Page: 160 / 192

148 Installing, Removing, and Replacing
a. With the I/E station door open, open the left door (the access door) of the module and pull the
door toward you in order to access the slot located in the lower left corner of the module. (The
flexible door hinge allows the door to be pulled away from the module, providing access to the
slot.)
b. Install the left rack ear in the same manner as the right rack ear.
c. Using two M5 thumbscrews, fasten the rack ear to the rack. The thumbscrews should fasten
completely and evenly.
9 Close the module’s doors.
10 Reinstall the tape drives to the library.
11 Cable your library as necessary, following the instructions provided in Cabling the Library on page 84.
12 Power on the library.
Adding, Removing, and Replacing Tape Drives
The tape drive enables you to connect the library to servers within your storage area network (SAN).
Note
You may need to pull the door toward you in order to access the slot.
Note
Newly added tape drives need to be installed and verified one at a time.
Alternatively, all of the tape drives can be added to the drive bays at one time
with no wait time between adding tape drives.