Tandberg Data Storage Library T128, User Manual

Page: 55 / 192

Tandberg StorageLibrary T128 User’s Guide 43
• Auto (NL) — Auto-configure trying N-Port first (default)
• The requested interface speed can be set to Auto (default), 1 Gbs, 2 Gbs, and 4Gbs. If you set the
speed to 4Gbs, a caution message appears informing you that the 4Gbs speed selection may not
be applicable to all FC tape drives installed in the library. Acknowledge the message by clicking
OK .
• The screen also displays the actual FC topology connection mode and interface speed. If the
requested topology setting is not supported, the next appropriate setting is negotiated and appears
in the
Actual column. If FC drives are not connected to the host, the negotiated actual settings
appear on the screen as "unknown."
The paths to open the appropriate screens are as follows:
• From the web client, select Setup > Drive IDs .
• From the operator panel, select Setup > Drive IDs .
Modifying the Control Path
The control path tape drive is used to connect a partition to a host application. Only one tape drive can be
selected as the control path at one time. By default, the first tape drive assigned to a partition is designated
the control path. In the event that the control path connection to the host application fails, you can select a
new control path for the partition.
After you modify the control path, the library will reset the tape drive by changing the drive mode from online
to offline and then back to online.
The paths to open the appropriate screens are as follows:
• From the web client, select Setup > Control Path .
• From the operator panel, select Setup > Control Path .
Applying License Keys
The Setup Wizard: Licensing screen prompts you to enter a license key. You can also access the
Licensing screen directly on the operator panel and web client.
A single license key may be applied to the library during the initial configuration or whenever licensed
features are purchased. If an additional feature is purchased, the new license key will replace the current
license key.
Note
Bold column headings in the table can be sorted. For example, selecting the
Location column heading will sort by location coordinates.
Note
You may need to modify settings in your host application as a result of
modifying the control path. See your host application documentation.
Note
Bold column headings in the table can be sorted. For example, selecting the
Location column heading will sort by location coordinates.