Tandberg Data Storage Library T128, User Manual

Page: 102 / 192

90 Installing, Removing, and Replacing
Installing a New 14U Library Configuration
Use this procedure for installing a new 14U library. A 14U library contains a control module and one 9U
expansion module.
Preparing to Install a 14U Library
Required tools:
• Phillips #2 screwdriver, for removing and replacing the top cover plate
• T10 TORX screwdriver, for removing and replacing the bottom cover plate
1 Prepare the rack to hold modules, if you want to install your library in a rack. See Installing the
Rackmount Kit on page 138 for instructions on installing a rackmount kit.
2 Make sure all tape drives have been removed from all of the modules you plan to install. See Adding,
Removing, and Replacing Tape Drives on page 148 for instructions on removing tape drives.
3 Make sure all power supplies have been removed from all of the modules you plan to install. See
Adding, Removing, and Replacing Power Supplies on page 136 for instructions on removing power
supplies.
4 Park the robot assembly in the control module. Before unstacking the library, the robot assembly must
be placed in the control module.
a. Open the I/E station and access doors of each module.
b. Using your hands, gently lift the robot assembly into the control module. The robot assembly
should glide slowly and with some resistance.
c. After raising the robot assembly to the approximate middle of the control module, hold it in place
with one hand and, using your other hand, swivel the parking tab toward you. The metal parking
tab is located at the bottom of column 1.
There are no restrictions on where the 5U control module can be
installed in the 14U library configuration. However, the recommended
placement of the 5U control module is on top of the 9U expansion
module. 5U Control Module
9U Expansion
Module
WARNING
ALL LIBRARIES MAY BE INSTALLED IN A RACK HAVING A MAIN
PROTECTIVE EARTHING (GROUNDING) TERMINAL, AND POWER
MUST BE SUPPLIED VIA AN INDUSTRIAL PLUG AND
SOCKET-OUTLET AND/OR AN APPLIANCE COUPLER COMPLYING
WITH IEC 60309 (OR AN EQUIVALENT NATIONAL STANDARD) AND
HAVING A PROTECTIVE EARTH (GROUND) CONDUCTOR WITH A
CROSS SECTIONAL AREA OF AT LEAST 1.5 MM
2
(14 AWG).
TO ENSURE PROPER AIRFLOW AND ACCESS SPACE, ALLOW 60 CM
(24 INCHES) IN THE FRONT AND BACK OF THE LIBRARY.
CAUTION
Support the robot assembly by holding onto the broad metal X-axis
plate. Lifting the robot by the thin metal rod will bend the rod.