Tandberg Data Storage Library T128, User Manual

Page: 29 / 192

Tandberg StorageLibrary T128 User’s Guide 17
Setting Up the Library
This chapter provides an overview of the steps required to unpack, set up, and install the Tandberg
StorageLibrary T128 library.
For basic library setup instructions, see the Quick Start Guide. A copy of the Quick Start Guide is included
in the product box with your library.
For complete installation instructions, see Installing, Removing, and Replacing on page 83.
Unpacking the Library
This section includes instructions on unpacking your library. Follow the information in this section so as not
to harm yourself or the library and its components.
Unpacking and Inspecting
1 Unpack the library .
Following the unpacking instructions that came with the library, remove the library exterior packaging
but leave the library in the bottom packaging tray.
2 Check the contents of the package against the packing slip.
3 Remove the interior packaging .
After you have removed the packaging sleeve and while the library is still sitting in the bottom packaging
tray, remove all packaging from the interior of the library.
WARNING
WITHOUT TAPE DRIVES, TAPE CARTRIDGES, OR POWER
SUPPLIES, A 5U CONTROL MODULE WEIGHS APPROXIMATELY 58
LBS. A 9U EXPANSION MODULE, WITHOUT TAPE DRIVES, TAPE
CARTRIDGES, OR POWER SUPPLIES, EXCEEDS 65 LBS. TO AVOID
SERIOUS INJURY, TWO PEOPLE ARE REQUIRED TO SAFELY LIFT
THE MODULES INTO POSITION.
CAUTION
Save all packing materials in case you need to move or ship the
library in the future.