TAKASAGO HX-S-01000-12G2, Instruction Manual

Page: 32 / 240

Basic Usage
32
Remote Sensing
Remote sensing is used for solving problems with voltage drop between the output terminal and load due to wiring
by compensating for the voltage drop. Remote sensing is able to compensate voltages up to 5V
per direction (one-
way).
Wire as shown in the diagram below.
* Crimping terminal to connect to a remote sense terminal, please use the crimp terminal with an isolation coating.
* The figure above is an example of connecting HX-S-0500-12G2.
C1: Electrolytic Capacitor 100 to 1000 μF
(Low Impedance Item)
C2: Film Capacitor 1 to 10 μ
Ｆ
Connect when wishing to lower output
ripple/noise from the load terminal.
MEMO
Turn POWER switch OFF before wiring to the output terminal.
！
DANGER
●
While using remote sensing, do not switch output lines using switches, etc.
Doing so may lead to damaging the power supply..
● Because the output terminal’s voltage is detected by the OVP circuit, please
set the voltage value of the OVP to include the voltage drop amount (round
trip) of the wires outputting the voltage you wish to protect.
！
CAUTION
Load
＋
－
C1
C2
If you want to ground it is done at the
load end.
Wiring
material
Do wiring material
twisting,Route as close as
much as possible.
M5 Screw
M5 Crimping
terminal
Output Terminal
Cover
M3 Screw
HX30-200/60V/120V Type
Remot e sense terminal
『
+
』
(M3 Screw)
Remot e sense terminal
『
+
』（
Accessory
connector
）
HX30-400 Type HX400V/500V Type HX1000V Type
Remot e sense terminal
『
+
』
(M3 Screw)
Remot e sense terminal
『－』
(M3 Screw)
Remot e sense terminal
『－』
(M3 Screw)
Remot e sense terminal
『－』（
Accessory
connector
）
Remot e sense terminal
『
+
』（
Accessory
connector
）
Remot e sense terminal
『－』（
Accessory
connector
）