TAKASAGO HX-S-01000-12G2, Instruction Manual

Page: 174 / 240

Calibration
174
Offset/Full-Scale Calibration of Output Voltage with External Analog Input
Output Voltage Control with External Voltage (Isolated External Voltage)
1. Disconnect the load wires and the remote sensing
wires. Connect the digital multimeter to the output
terminal.
Turn the POWER switch ON and OUTPUT OFF in
advance.
Power Supply
+
-
V
+
-
Digital
Multimeter
Calibration Circuit
3
16
External
Control Connector
External
Voltage
0 to 10V
Insulation
Control Connector
5
4
2. Set the external voltage to 0.010V and the constant
current setting value to [ yA ] and set the output to
ON.
30-200 30-400 60-100 60-200
[yA] 1.0A 1.0A 1.0A 1.0A
500-12 500-24 1000-6 1000-12
[yA] 0.10A 0.10A 0.010A 0.10A
120-50 120-100 400-15 400-30
[yA] 0.10A 1.0A 0.10A 0.10A
On how to set, refer to Output Voltage Control with
ExternalVoltage.(page149)
In the case of isolation, refer to Output Voltage
Control with Isolated External Voltage.
(page150)
3. Press the FUNC. key.
4. Turn the VOLTAGE dial to display the setting item
number 28 in the Number Display (voltage).
* At that time, turn off the Number Display (current).
5. Adjust so that the output voltage becomes
[ xV ] with the CURRENT dial.
30-200 30-400 60-100 60-200
[xV] 0.03V 0.03V 0.06V 0.06V
500-12 500-24 1000-6 1000-12
[xV] 0.5V 0.5V 1.0V 1.0V
120-50 120-100 400-15 400-30
[xV] 0.12V 0.12V 0.4V 0.4V
6. Press the FUNC. key to settle the offset calibration
value of output voltage control with external
voltage.