TAKASAGO HX-S-01000-12G2, Instruction Manual

Page: 105 / 240

Using via Digital Data Communication
105
SYSTem:COMMunicate:SERial[:RECeive]:PARity[:TYPE]
: Sets the parity
Function: Sets the parity
Same as FUNCTION Settings Item 62
Format: SYSTem:COMMunicate:SERial[:RECeive]:PARity[:TYPE] <String>
Type: SET command, QUERY command
Parameters: ODD: Odd number
EVEN: Even number
NONE: None
Response: ODD, EVEN, NONE
Restrictions: Alarm response is returned for normal SET commands in the following conditions
- While operating as a series operation slave unit
- While operating as a parallel operation slave unit
<Ex.>
SYST:COMM:SER:PAR ODD
SYST:COMM:SER:PAR?
ODD
SYSTem:COMMunicate:SERial:UNIT
: Sets Query Response Unit Load
Function: Sets whether to add-on units to the Query Response.
Format: SYSTem:COMMunicate:SERial:UNIT <NRf>
Type: SET command, QUERY command
Parameters: 0: Do not add units (Default Settings)
1: Add-on units
Response: Same as parameters
Explanation: If set to "Add-on unit", the units shown below will be added-on to the response.
V: Added to responses for Output Voltage Settings, OVP Settings, Voltmeter Measurement
Query commands
A: Added to responses for Output Current Settings, OCP Settings, Ammeter Measurement
Query commands
kW: Added to responses for Power Measurement Query Commands
s: Added to responses for Rising/Down Delay Time Setting Query Commands
Ohm: Added to responses for Internal Resistance Setting Query Commands
bps: Added to responses for Bitrate Setting Query Commands
<Ex.>
SYST:COMM:SER:UNIT 1
SYST:COMM:SER:UNIT?
1
VOLT?
80.0V
Setting changes via this command will take effect from next command.
！
CAUTION