TAKASAGO HX-S-01000-12G2, Instruction Manual

Page: 173 / 240

Calibration
173
7. Set the constant voltage setting value to [ xV ] and
the constant current setting value to [ yA ] and set
the output to ON.
30-200 30-400 60-100 60-200
[xV] 1.00V 1.00V 1.00V 1.00V
[yA] 200.0A 400.0A 100.0A 200.0A
500-12 500-24 1000-6 1000-12
[xV] 1.0V 1.0V 1V 1V
[yA] 12.00A 24.00A 6.000A 12.00A
120-50 120-100 400-15 400-30
[xV] 1.0V 1.0V 1.0V 1.0V
[yA] 50.00A 100.0A 15.00A 30.00A
On how to set, see Operating as Constant Current
Power Supply under Basic Operations. (page30)
8. Press the FUNC. key.
9. Turn the VOLTAGE dial to display the setting item
number 23 in the Number Display (voltage).
* At that time, turn off the Number Display (current).
10. Adjust so that the output current becomes [ yA ]
with the CURRENT dial.
30-200 30-400 60-100 60-200
[yA] 200.00A 400.00A 100.00A 200.00A
DMM display
value
50.00mV 40.00mV 25.00mV 50.00mV
500-12 500-24 1000-6 1000-12
[yA] 12.000A 24.000A 6.000A 12.000A
DMM display
value
40.00mV 40.00mV 30.00mV 40.00mV
120-50 120-100 400-15 400-30
[yA]
50.000A 100.00A 15.000A 30.000A
DMM display
value
12.50mV 25.00mV 50.00mV 50.00mV
*DMM display value is the specification of the shunt resistor
The value when had you use.
11. Press the FUNC. key to settle the full-scale
calibration value of the output current settings.
12. This completes offset/full-scale calibration of
output current.
Set the constant voltage setting value and the
constant current setting value to the original ones
and start using.
Be certain to perform this along with meter
calibration (Offset/Full-Scale Calibration of
Voltmeter.)
！
CAUTION