TAKASAGO HX-S-01000-12G2, Instruction Manual

Page: 153 / 240

Controlling with External Analog & Contact Signals
153
2. Output Current Control with External Resistance(B)
This section describes how to set the output current to zero when
the external resistance value is zero (short).
The output current is derived from the following formula.
Output Current [A]
=
10
] [ Resistance External
] [ Current Output Max.
ｋΩ
Ａ

The output accuracy for the external resistance, is the set current ±
(0.5% of Rated Output Current).
Connecting
Connect the resistor between No. 6 and 19 of the external control connector (accessory).
Setting Procedures
Set the parameter to 3 (External Resistance Type B) according to the procedure on page 152
6
19
0～10kΩ
External Control Connector
Twisted-Pair Wire
External Resistance
Output Current Control with External Resistance(B)

The commons for analog signal (external control connector No. 19) is internally connected to
the minus side of the output terminal.
 Isolation for the wire connecting to the external control should be more than the relative ground
voltage of this product.
Otherwise, the user may receive electric shock.
 The External Resistance A, B, and C and the External Voltage cannot be used together to
control the output.
 If the external resistance opens for even a moment, the output will generate an over voltage.
！
CAUTION
MAX
0
External Resistance
O
u
tp
u
t C
u
rr
e
n
t
CC_RB
10k
Ω