TAKASAGO HX-S-01000-12G2, Instruction Manual

Page: 100 / 240

Using via Digital Data Communication
100
[SOURce]:VOLTage:SLEW:RISing
: Sets CV Slew Rate Rising
Function: Sets the CV slew rate for rising.
Same as FUNCTION Settings Item 2
Format: [SOURce]:VOLTage:SLEW:RISing <NRf>
Type: SET command, QUERY command
Parameter: 30VType: 0.01 to 60.00/ 60VType:0.1 to 120.0/ 500VType: 1 to 1000/ 1000VType: 1 to 2000
Response: Same as parameters
Restrictions:
Alarm response is returned for normal SET commands in the following conditions
· Cases other than full-featured type "model name with F"
·
While operating as a series operation slave unit
·
While operating as a parallel operation slave unit
<Ex.>
VOLT:SLEW:RIS 60.0
VOLT:SLEW:RIS?
60.0
[SOURce]:VOLTage:SLEW:FALLing
: Sets CV Slew Rate Falling
Function: Sets the CV slew rate for falling.
Same as FUNCTION Settings Item 3
Format: [SOURce]:VOLTage:SLEW:FALLing <NRf>
Type: SET command, QUERY command
Parameter: 30VType: 0.01 to 60.00/ 60VType:0.1 to 120.0/ 500VType: 1 to 1000/ 1000VType: 1 to 2000
Response: Same as parameters
Restrictions:
Alarm response is returned for normal SET commands in the following conditions
·
Cases other than full-featured type "model name with F"
· While operating as a series operation slave unit
·
While operating as a parallel operation slave unit
<Ex.>
VOLT:SLEW:FALL 0.1
VOLT:SLEW:FALL?
0.1
STATus Level
STATus level command corresponds to retrieving status information.
Command Name Summary Command Type
STATus - -
:MEASure - -
:CONDition Retrieves Power Supply Status QUERY Only
： OUTPut － －
： MODE
Selection of status output function Both

Continued on next page