SYSMEX XE-5000, Instruction Manual, Page: 92 / 262

CHAPTER 6 Operation
6-38 Sysmex XE-5000 Instructions for Use
R
e
vi
se
d A
p
ri
l 20
07
For details of the display methods on the Information
Processing Unit (IPU), see “Chapter 3: Stored Samples
(Explorer)” and “Chapter 4: Data Browser” in the Software
Guide.
6.25 Timer processing
When timer mode is used, the Pneumatic Unit power
automatically turns OFF if the Main Unit does not detect any
operation within a preset amount of time. When the backlight
on the LCD of the Main Unit is kept on for the specified time,
brightness becomes darker in order to protect the LCD
screen.
For the setting method, see “Chapter 5: Instrument Setup” in
the Software Guide.
Recovery procedure
• When the start switch is pressed, the brightness of the LCD
screen resets. The Pneumatic Unit also resets at the same
time.
• When a numeric key on the panel keypad is pressed, the
brightness of the LCD screen resets. The Pneumatic Unit
also resets at the same time.
Information
• Analysis results from the analysis performed without
canceling an “Execute Background check” error are
marked with an “F” mark on a red background on the
IPU, and an asterisk “*” is displayed on the left of the
“F” mark on the main unit LCD screen.
• Results analyzed in body fluid analysis mode are not
subject to automatic validation, regardless of the
automatic validation setting. Check the display status
of the “F” mark and perform validation carefully.
Note:
• Analysis parameter results other than WBC-BF,
RBC-BF, MN#, MN%, PMN# and PMN% are not
displayed, if the analysis was performed in the body
fluid analysis mode.
• Even if a patient ID is attached to the analysis results
obtained through body fluid analysis, the results will
not be subject to the cumulative data display.
START Switch