SVP HDT-02, User Manual

Page: 207 / 233

HDT-02_H.264 High Definition Digital Camera Transmitter
MANUAL V9.9 207
B.3.1 Power supply
The equipment can be powered by a DC source from 11 to 16 V or through
the V battery clamps.
The DC power supply is connected to the equipment via a 4 pin Lemo 1B
connector.
Item Features
Connector label POWER DC
Connector type 4 pin Lemo 1B
Input voltage range 11-16 V
Consumption 4 Watt: 2,9A @ 12V
Table B.2: Power supply connection technical features
The pin-out of the power supply connector is:
• 1 and 2 pins --> ground
• 3 and 4 pins --> from 11 to 16 V
B.3.2 RF Input
The RF input of the HDT-02 camera Transmitter is connected to the RF input
of the PAC amplifier. A very low loss cable should be used to make this
connection.
Item Features
Connector label RF IN
Frequency range 2,0 to 2,5 GHz frequency band
(Other frequency bands upon request)
Input Level 10 to 100 mW (10 to 20 dBm)
Connector type N female
Impedance 50 Ω
Table B.3: RF input connection technical features
Note: In some Transmitters, increasing the output power implies output
signal quality degradation due to intermodulation. Normally, at low powers a
better shoulder level is obtained. SVP Broadcast Microwave recommends
using the Transmitters configured with the lowest output power.