SVP HDT-02, User Manual

Page: 72 / 233

HDT-02_H.264 High Definition Digital Camera Transmitter
MANUAL V9.9 72
4.6.1.15 KLV Metadata
When this option is ON, the KLV Metadata embedded on the SDI signal is sent
through the radio link.
If KLV metadata is not embedded on SDI input, the HDT-02 Transmitter will
show an alarm indicating that the KLV is not present.
Once that KLV is received at ground, using the TS over IP output of the
receiver, KLV metadata can be monitored by a Mission Monitor program.
4.6.1.16 Encoder Output
The encoder output option allows the configuration of the transport stream
bitrate. When you use the Transmitter
’s ASI output , the output bitrate can
be set manually on this screen. When the RF is enabled, the modulator starts
working and the output bitrate is set by the modulation parameters, changing
automatically to Auto mode.
Figure 4.34: Encoder Output Menu
Line nº Function
1
Bit Rate (eligible parameter) :
In this field, the output bitrate is shown. When it is wanted to select
between an automatic bitrate or configure manually the bitrate,
press Right, Left buttons. If manual configuration is selected then,
press OK button to select the desired bitrate with the UP, Down keys.
Press the OK button to save the introduced value.
The available options are:
• Auto
• Manual (editable parameter)
Figure 4.35: Encoder Output menu options
Figure 4.33: KLV Metadata option
Encoder
KLV Metadata: Off >
Encoder Output
TS Parameters