SVP HDT-02, User Manual

Page: 7 / 233

HDT-02_H.264 High Definition Digital Camera Transmitter
MANUAL V9.9 7
Important Notes
• The HDT-02 H.264 High Definition multiband Transmitter is completely
compatible with the DVB-T/T2/S/S2 Standards, included in the
European Standard ETSI EN300744 (DVB-T), ETSI EN300755 (DVB-T2),
ETSI EN302307 (DVB-S2) (optional) and ETSI EN300421 (DVB-S)
(optional). It also complies with the ISDB-T International technical
standard (optional).
• It is important to note that when the Transmitter is switched on, the
selected RF output connection must be connected to a suitable antenna
or charged.
• The HDT-02 H.264 High Definition multiband Transmitter applies a
MPEG-4 compression to either HDMI, composite video or SDI input
signals. An MPEG-1 layer 2 compression is applied to the corresponding
4 analogue Audio channels, the 2 stereo SDI embedded, the HDMI
embedded and the AES digital Audio signals. The resulting multiplexed
signal is transmitted using COFDM modulation.
• The HDT-02 H.264 High Definition multiband Transmitter is available
from 1 GHz to 6.4 GHz, for the DVB-T2, DVB-T and optionally ISDB-T
RF stage. The L band output for the DVB-S2 and DVB-S is optional.
• If the RF output is set to DVB-T2 and the selected bandwidth is 1.7 MHz
then, the device automatically disables the Audio2 and it sets the bitrate
of the Audio1 to 128 Kbps.
• The e quipment’s maximum output power for the DVB -T2/T and ISDB-T
is 100 mW in 2 GHz frequency band, (selectable from -5 to +20 dBm)
and for the DVB-S2 and DVB-S is from -50 to + 5 dBm.
• Special care should be taken with SDI cables, quality and length, as
these are very important, especially when HD-SDI or 3G SDI signals are
transmitted.
• If any Audio or data channel are not used in a transmission, they should
be disabled, in order to assign that bitrate to the video and achieve a
higher quality transmitted video signal.
• Only authorized personnel should open the unit and any repair or
warranty will be invalidated if the seals are broken.