SVP HDR-106, Manual

Page: 99 / 213

98
HDR-106 MPEG2/H264 – 4:2:2 – 10 bits – DVB-T2/T Diversity 6 – DVB-S2/S Receiver
MANUAL 7.0
4.2.2 Configuration
Next, it is explained how to configure the autotracking with a
parabolic
antenna .
The QuickSet positioner must be calibrated. This means that it must be
straightened and oriented 0 degrees to the North.
If during 15 seconds there is no GPS signal, the device will look for it. If
there is no GPS signal but there is RF signal then, the tracking will be at
maximum RF signal received.
1)
Go to the Input Select menu. In case of being in the main screen, press
cross button so as to access to the menu. There, with the Up, Down
buttons, select the Input Select option and the standard used. In this
case, the example is shown as if it was configured in DVB-T.
Figure 4.8 Input Select menu
2) Go to Autotracking option.
Figure 4.9 Antenna Control menu
In this option, there are three possible types of autotracking (Sectorial,
Parabolic and Omnidirectional). In this case, select the parabolic option with
the Right, Left keys. Once the option is selected, press the OK button so as
to enter to the configuration menu.
3) Once the user is inside the parabolic option, there are four possible
options (eligible with the Right, Left keys) which are detailed below:
I. Auto
Figure 4.10 Parabolic Autotracking (Auto)
When the Auto option is selected, it means that the parabolic
antenna is aimed automatically to the transmitter device throughout
the GPS coordinates of the transmitter and the receiver device.
DVB-T

Autotracking: Parabolic <
01 Input Select: DVB-T >
02 Decoder
H: 061º V: 09º Δd: ---.-km ΔH:---m Auto >
L1 [ ]:-- C/N [ ]:-