106
HDR-106
MPEG2/H264 – 4:2:2 – 10 bits – DVB-T2/T Diversity 6 – DVB-S2/S Receiver
MANUAL 7.0
Chapter 6: Web Server / SNMP
6.1
Introduction
This equipment can be controlled by the use of a PC connected at the rear
panel Ethernet connector
,
through the Internet or a local network. The
Remote connector of the receiver is used for this purpose.
To enable the browser interface correctly, the IP address, Subnet Mask and
Gateway need to be set correctly on this unit. Next, the steps so as to setup
network parameters are shown:
1.
Go to Unit -> Webserver & SNMP
Figure 6.1 Web Server screen
2.
Select Locl option and set an IP address. So as to change the IP
address first press the OK button and then, with the Up, Down keys
select the desired number. So as to change from one character to
another, press Right, Left keys. Press the OK button so as to save the
introduced value.
Figure 6.2 Local IP
3.
Select Mask option and set the Subnet Mask. So as to change the
Subnet Mask address first press OK button and then, with the Up,
Down keys select the desired number. So as to change from one
character to another, press Right, Left keys. Press the OK button so
as to save the introduced value.
Figure 6.3 Subnet Mask
04 IP Output: Enable
<
05 Unit
Unit
Monitor
Unit
Webserver & SNMP
Locl: 192.168.001.010
Mask: 255.255.000.000
Locl: 192.168.001.010
Mask: 255.255.000.000
Summary of Contents for HDR-106
Page 208: ...207 HDR 106 MPEG2 H264 4 2 2 10 bits DVB T2 T Diversity 6 Receiver MANUAL V7 0...
Page 209: ...208 HDR 106 MPEG2 H264 4 2 2 10 bits DVB T2 T Diversity 6 Receiver MANUAL V7 0...
Page 210: ...209 HDR 106 MPEG2 H264 4 2 2 10 bits DVB T2 T Diversity 6 Receiver MANUAL V7 0...
Page 211: ...210 HDR 106 MPEG2 H264 4 2 2 10 bits DVB T2 T Diversity 6 Receiver MANUAL V7 0 Notes...