SVP HDR-106, Manual

Page: 76 / 213

75
HDR-106 MPEG2/H264 – 4:2:2 – 10 bits – DVB-T2/T Diversity 6 – DVB-S2/S Receiver
MANUAL 7.0
Line nº Function
1
Local IP Config:
In this field, different parameters related to the configuration of the
local network can be set.
The available parameters are:

Local:
IP address of the device which is going to send the information.
So as to change the IP address first press the OK button and
then, with the Up, Down keys select the desired number. So as
to change from one character to another, press Right, Left keys.
So as to save the value, press the OK button. (editable
parameters)

Mask:
Subnet address of the device which is going to send the
information. So as to change the Subnet Mask address first press
the OK button and then, with the Up, Down keys select the
desired number. So as to change from one character to another,
press Right, Left keys. So as to save the value, press the OK
button. (editable parameters)

Gateway:
Gateway address of the device which is going to send the
information. So as to change the Gateway address first press the
OK button and then, with the Up, Down keys select the desired
number. So as to change from one character to another, press
Right, Left keys. So as to save the value, press the OK button.
(editable parameters)
2
Dest IP & Port:
In this option, the IP address and the number of the port of the
device to which data is sent must be configured. In case it is wanted
to send data to a multicast address just enter the desired multicast
address. So as to change the IP address and the number of the port,
first press the OK button and then, with the Up, Down keys select
the desired number. So as to change from one character to another,
press Right, Left keys. So as to save the value, press the OK button.
(editable parameter)
3
Fec:
In this field the Forward Error Correction can be enabled or disabled.
In case it is enabled, the number of columns and rows can be
configured pushing firstly the OK button and then, with the Up,
Down arrows, the number of columns and rows wanted can be
selected. If FEC option is enabled then, the only protocol which can
be used is RTP. (eligible parameter and editable if enable option is
chosen)