SVP HDR-106, Manual

Page: 97 / 213

96
HDR-106 MPEG2/H264 – 4:2:2 – 10 bits – DVB-T2/T Diversity 6 – DVB-S2/S Receiver
MANUAL 7.0
When the Auto option is selected, it means that the sector antenna
is automatically selected. The selected sector is the one which is
marked with the square brackets.
II. Manual
Figure 4.5 Sector Autotracking (Manual)
If the Manual option is selected then, by pressing the OK button the
user can select manually the sector antenna from which it is wanted
to receive the signal.
Manual option can only be selected in case there is no remote GPS signal. If
the option is configured in manual and the receiver recovers the GPS
coordinates then, the option will turn to be GPS again.
If the option selected is GPS and the device is receiving signal but the GPS
data disappears, the device will be in a tracking mode automatically. It will
stay two seconds in each sector until GPS data is received.
In case there is no GPS signal but the device is receiving the RF signal, the
device will be kept in the same sector, it will not be tracking.
III. Config
Pressing the OK button when the Config option is selected, the user
is allowed to configure the number of the sectorial antennas, the
degrees of the sectors and if a top antenna is included.
Figure 4.6 Sector Autotracking (Config)
Using the Up, Down keys the user can change the value of each
parameter and with the Right, Left buttons the user can select the
value to be modified. So as to save the values, the OK button must
be pressed.
1 2 3 [4] 5 T Δd:---.-km Man<>
L [ ]:-- C/N [ ]:-
1 2 3 [4] 5 T Config <
Nr. Ant: 6 Deg: 75º UP:Yes Rem.GPS:AUTO