SVP HDR-106, Manual

Page: 77 / 213

76
HDR-106 MPEG2/H264 – 4:2:2 – 10 bits – DVB-T2/T Diversity 6 – DVB-S2/S Receiver
MANUAL 7.0
4
TP per IP:
In this field the number of Transport Stream packets per IP (from 1
to 7) can be configured. So as to select the desired value, press the
Right and Left buttons. (eligible parameter)
5
Protocol:
The type of protocol used for the communication can be RTP or UDP.
So as to select the desired protocol for the communication, use
Right and Left buttons. (eligible parameter)
6
Time to Live:
This field limits the lifetime of the data. The Time to Live value (from
1 to 255) means the number of routers that a packet can reach until
that packet is discarded. So as to configure this value, first press the
OK button and then, with the Up, Down, Right and Left buttons
select the desired value. So as to save the value, press OK button.
(editable parameter)
7
IP/ASI Output:
In this field, the use of the BISS encryption in the IP and ASI
outputs of the receiver can be configured. (eligible parameter)
The available options are:

Standard:
In this option, if the transmitter’s signal is encrypted, there will
be encryption in the IP and ASI outputs of the receiver. If the
transmitter’s signal works without encryption, there will not be
encryption in the ASI and IP outputs of the receiver.

Always Descrambled:
In this option, the IP and ASI outputs of the receiver will always
be without encryption.
Table 3.19 IP Output menu options
The Local IP address and the destination IP address must be
different.
When a parameter of the TS over IP menu options is changed, it
takes 30 seconds to the device to be configured and work again.