Supero FatTwin F627R3-R72B+, User Manual

Page: 109 / 152

Chapter 6: Advanced Chassis Setup
6-25
Figure 6-24: Removing the System Fans from the Fan Housing
Squeeze the
Release Tabs
Squeeze the
Release Tabs
1
8
1
7
1
7
6. Lift the fan housing up and out of the chassis.
7. Simultaneously squeeze both sets of release tabs on each side of the fan
housing. This will release the cover plate of the housing which holds the fans
inside the housing. Either the front or rear cover plate may be reseased.
8. Pull the cover plate off the fan housing.
9. Remove the four rubber spacers from the housing.
10. Pull out the failed fan and replace it with a new one.
11. Reinstall the rubber spacers in the fan housing.
12. Reinstall the face cover of the fan housing, by aligning the release tabs with
their slots in the housing and gently pushing the face cover onto the housing
until it clicks into the locked position.
13. Reconnect the cabling to both fans.
14. Reinstall the fan housing in the motherboard node and secure it to the fl oor of
the node with the four screws which were previously set aside.
15. Return the node to its bay in the chassis.