Supero FatTwin F627R3-R72B+, User Manual

Page: 77 / 152

Chapter 5: Advanced Motherboard Setup
5-23
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system moni-
tor that will reboot the system when a
software application hangs. Close Pins
1-2 to reset the system if an applica-
tion hangs. Close Pins 2-3 to generate
a non-maskable interrupt signal for the
application that hangs. See the table on
the right for jumper settings. Watch Dog
must also be enabled in the BIOS.
Watch Dog (JWD1)
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled
VGA Enable (JPG1)
Jumper Settings
Jumper Setting Defi nition
1-2 Enabled (Default)
2-3 Disabled
BMC Enable (JPB1)
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 BMC Enable (Default)
Pins 2-3 Normal
I2C to PCI-Exp (JI2C1/JI2C2)
Jumper Settings
Jumper Setting Defi nition
1-2 Enabled
2-3 Disabled (Default)
GLAN Enable/Disable
JPL1 enables or disables the LAN Port1/
LAN Port2 on the motherboard. See the
table on the right for jumper settings.
The default setting is Enabled.
GLAN Enable
Jumper Settings
Jumper Setting Defi nition
1-2 Enabled (default)
2-3 Disabled
VGA Enable
Jumper JPG1 allows the user to enable
the onboard VGA connectors. The
default setting is 1-2 to enable the
connection. See the table on the right
for jumper settings.
BMC Enable
Jumper JPB1 allows you to enable the
onboard BMC (Baseboard Management)
Controller to provide IPMI 2.O/KVM
support on the motherboard. See the
table on the right for jumper settings.
I2C Bus to PCI-Exp. Slots
Jumpers JI 2 C1 and JI 2 C2 allow you to
connect the System Management Bus
(I 2 C) to PCI-Express slots. The default
setting is Open to disable the connection.
See the table on the right for jumper
settings.