Supero FatTwin F627R3-R72B+, User Manual

Page: 58 / 152

5-4
FatTwin F627R3-RTB+/R72B+ User's Manual
Installing the LGA2011 Processor
1. There are two load levers on the LGA2011 socket. To open the socket cover,
fi rst press and release the load lever labeled 'Open 1st'.
OPEN 1st OPEN
1st
WARNING! WAR
NIN
G!
Press down on Load
Lever labeled 'Open 1st'.
OPEN 1st OPEN
1st
WARNING! WAR
NIN
G!
5-4 Processor and Heatsink Installation
Warning! When handling the processor package, avoid placing direct pressure on
the label area.
Warning! If you buy a CPU separately, make sure that you use an Intel-certifi ed multi-
directional heatsink only.
Note: Always connect the power cord last, and always remove it before adding,
removing or changing any hardware components. Make sure that you install the
processor into the CPU socket before you install the CPU heatsink.
Note: Make sure to install the system board into the chassis before you install the
CPU heatsink.
Note: When receiving a server board without a processor pre-installed, make sure that
the plastic CPU socket cap is in place and none of the socket pins are bent; otherwise,
contact your retailer immediately.
Note: Refer to the Supermicro website for updates on CPU support.
Note: When one CPU is installed, be sure to installed on CPU Socket 1 fi rst.
Note: Graphics and drawings shown in this manual are for illustration only. Your
components may or may not look the same as the graphics shown in the manual.