Supero FatTwin F627R3-R72B+, User Manual

Page: 110 / 152

6-26
FatTwin F627R3-RTB+/R72B+ User's Manual
6-15 Replacing the Power Supply
The SCF424AS chassis includes a 1280 Watt power supply. This power supply
is auto-switching capable. This enables it to automatically sense and operate at a
100v to 240v input voltage. An amber light will be illuminated on the power supply
when the power is off. An illuminated green light indicates that the power supply
is operating.
Power Supply Replacement
The SCF424AS chassis utilizes two redundant power supplies (four in total). In the
unlikely event that the power supply unit needs to be replaced, one power supply can
be removed, without powering down the system. Replacement units can be ordered
directly from Supermicro (See the contact information in the Preface of this manual).
Changing the Power Supply
1. Power down the system and remove the power cord from the rear of the
power supply as described in Section 6-3. Remove the node from the chassis
as described in Section 6-4 and place the node on a fl at, stable surface.
Remove the cover from the node as described in Section 6-6.
2. Press the release tab on the back of the power supply and pull the power
supply out using the handle provided.
3. Push the replacement power supply module into the power bay until it clicks
into the locked position.
4. Plug the AC power cord back into the module and return the node to its bay
in the chassis..
Release Tab
Figure 6-25: Changing the Power Supply
(Your chassis and nodes may differ from the one shown in the illustration)