Supero FatTwin F627R3-R72B+, User Manual, Page: 56 / 152

5-2
FatTwin F627R3-RTB+/R72B+ User's Manual
5-3 Control Panel Connectors and I/O Ports
The rear I/O ports are color coded in conformance with the PC 99 specifi cation. See
Figure 5-1 below for the colors and locations of the various I/O ports.
Figure 5-1. Rear I/O Ports
2 1 5 3 4 6
5-2 Connecting Cables
Now that the processors are installed, the next step is to connect the cables to
the serverboard.
Connecting Data Cables
The cables used to transfer data from the peripheral devices have been carefully
routed in preconfi gured systems to prevent them from blocking the fl ow of cooling
air that moves through the system from front to back. If you need to disconnect
any of these cables, you should take care to reroute them as they were originally
after reconnecting them (make sure the red wires connect to the pin 1 locations). If
you are confi guring the system, keep the airfl ow in mind when routing the cables.
The following cables need to be connected for the FatTwin F627R3-RTB+/R72B+
system:
•
Eight (8) 29-cm 30AWG SATA cables (CBL-0483L)
•
Four (4) 4-pin 40-cm PDB-to-MB HF power cables (CBL-0480L)
F627R3-RTB+ only:
•
Eight (8) 27-cm PBF cables for SGPIO (CBL-0157L-02)
•
Twelve (12) 81-cm SATA 30AWG cables (CBL-0481L)
•
Twelve (12) 55-cm 30AWG SATA-SATA cables (CBL-0484L)
F627R3-R72B+ only:
•
Four (4) 23-cm, w/25.5-cm 30AWG Ipass-to-4 SATA cables (CBL-0118L-03)
•
Eight (8) 43-cm SATA round S-RA PBF cables (CBL-0226L)
•
Four (4) 27-cm PBF cables for SGPIO (CBL-0157L-02)