Supero FatTwin F627R3-R72B+, User Manual

Page: 57 / 152

Chapter 5: Advanced Motherboard Setup
5-3
Back Panel I/O Port Locations and Defi nitions
1. USB Port 1
2. USB Port 2
3. VGA Port
4. Gigabit LAN 1
5. Gigabit LAN 2
6. IPMI LAN
Connecting the Control Panel
JF1 contains header pins for various front control panel connectors. See Figure 5-1
for the pin locations of the various front control panel buttons and LED indicators.
Even and odd numbered pins are on opposite sides of each header.
All JF1 wires have been bundled into single keyed ribbon cable to simplify their
connection. The red wire in the ribbon cable plugs into pin 1 of JF1. Connect the
other end of the cable to the Control Panel printed circuit board, located just behind
the system status LEDs in the chassis.
See the Connector Defi nitions section in this chapter for details and pin descriptions
of JF1.
Figure 5-2. Front Control Panel Header Pins (JF1)
Power Button
PWR Good of BPN-ADP-F418
PWR Adaptor Card
1
Red LED (Failure)
Signal
UID Button
2
Fan Speed Signal 2
PS Failure
SMBUS CLK for Hot Swap on
BPN-ADD-F418 PWR Adp. Card
PWM for Fan to Backplane
LAN LED Signal
Ground
19 20
Fan Speed Signal 1
X
X
PS_ON_N to PS
Front Panel PWR LED
UID LED Signal
SMBUS DAT for Hot Swap on
BPN-ADD-F418 PWR Adp. Card SMBUS Alert for Hot Swap on
BPN-ADD-F418 PWR Adp. Card
PMBUS CLK
PMBUS DAT