Sun Microsystems StorEdge, Troubleshooting Manual, Page: 97 / 168

Appendix A Brocade Communications Systems Upgrades and Installations 79
Software Installation
For the Brocade Silkworm switch, the GUI capability is available through the switch
firmware and requires a Java-enabled browser on the host. Refer to “Related Brocade
Documentation” in Appendix B for instructions on how to access Brocade
documentation.
Note –
Once the packages have successfully installed, follow steps 6 through 13 in
“To Install the Software” on page 70.
▼
To Upgrade the Storage Automated Diagnostic
Environment Version 2.1 Package
For all upgrades, you must first install the most recent Sun StorEdge Network
Foundation Software patches. Refer to “To Install the Software” on page 70 for
installation instructions before installing the
SUNWstade
package and the Brocade
Communications Systems patch.
For detailed installation and usage instructions for the Storage Automated
Diagnostic Environment version 2.1, refer to the Storage Automated Diagnostic
Environment User’s Guide, Version 2.1.
1. If your SAN Management host is not running the current version, remove the
existing package and install the latest version. Remove the old package with the
pkgrm
command.
Removing the initial installation does not erase the previous configuration
information. The cache and topology information of each device is also retained to
maintain a consistent, historical view of the Sun StorEdge devices.
2. Reinstall the package using the following command:
3. Run
ras_install
to enable the
cron
and to configure the agent as master or
slave (a master agent acts as a collection point for events originating in other slave
agents).
4. Upgrade the master agent first.
# pkgrm SUNWstade
# pkgadd -d .