Sun Microsystems StorEdge, Troubleshooting Manual

Page: 148 / 168

130 Sun StorEdge SAN 4.0 Release Field Troubleshooting Guide • October 2002
DIAG-DATA
Err#266E, 306E
[portLoopbackTest,
crossPortTest]
Payload received by port did
not match payload
transmitted. mainboard, SFP
module or fiber
cable failure Replace mainboard
assembly, SFP module
or fiber cable
DIAG-ERRSTAT
Err#2640-2647, 3040-
3047, 3840-3847
[portLoobackTest,
crossPortTest, spinSilk]
Port Error Statistics counter is
non-zero, meaning an error
was detected when receiving
frames.
One of the following status
errors occurred.
• Enc_in—Encoding error,
inside frame
• CRC-err—Cyclic
redundancy check on
frame failed
• TruncFrm—Truncated
frame
• FrmTooLong—Frame too
long
• BadEOF—Bad end of file
• Enc_out—Encoding error,
outside frame
• BadOrdSet—Bad symbol
on fiber optic cable
• DiscC3—Discarded Class 3
frames
ASIC, mainboard,
SFP module or fiber
cable failure Replace mainboard
assembly, SFP
module, or fiber cable
DIAG-INIT
Err#264F, 304F, 384F
[portLoopbackTest,
crossPortTest, spinSilk]
Port failed to go active in the
loopback mode requested. ASIC, mainboard,
SFP module or fiber
cable failure Replace mainboard
assembly, SFP
module, or fiber cable.
DIAG-INTNIL
Err#2031
[cmiTest]
ASIC failed to get a CMI
error (interrupt) ASIC failure Replace mainboard
assembly
DIAG-INTNOTCLR
Err#102C
[centralMemoryTest]
The interrupt bit could not be
cleared. ASIC failure Replace mainboard
assembly
DIAG-LCMEM
Err#1027
[centralMemoryTest,
cmemRetentionTest]
Data read from the Central
Memory location did not
match data previously
written into the same location ASIC failure Replace mainboard
assembly
TABLE C-3
Diagnostic Error Messages (Continued)
Message Description Probable Cause Action