44
CHAPTER 3
3.2.11 EXITING
THE
CONFIGURE SYSTEM MENU
To Exit the Configuration System Menu:
Press the
PWR / MENU
button once to exit the
Configure System
Menu and return to the
Program Main Menu. Press the
PWR / MENU
button twice to go directly to the normal
operating mode.
Note:
Pressing the
PWR / MENU
button before pressing the
ENTER
button will cancel that configuration change.
Note:
If the
PWR / MENU
button is held too long the meter will display all 8’s and the meter will
turn off.
3.3 ENTERING
THE
SETUP / CALIBRATE MENU
To Enter the Setup / Calibrate Menu:
Enter the Program Menu (Section 3.1)
Press the
CYCLE
button until
SETUP / CALIBRATE
is displayed.
Press the
ENTER
button to select the
SETUP / CALIBRATE
Menu option.
3.3.1
SETTING THE TARE WEIGHT
GROSS VEHICLE & NET PAYLOAD WEIGHT METHODS
To properly calibrate a V600 system, all channels in use need to be calibrated. Listed below is a
procedure for entering the Tare weights. The Tare weights must be entered for each channel.
IMPORTANT:
The truck and trailer must not be in a twist or turn while setting the Tare weights.
June 21, 2006
VULCAN ON-BOARD SCALES 1-800-237-0022
Doc. 44-10032-001 Rev. C
©
STRESS-TEK, INC. 2006