66
CHAPTER 4
To Exit The SET: TARE WEIGHT Menu:
Press the
PWR / MENU
button once to exit the
Setup / Calibrate
Menu and return to the
Program Main Menu. Press the
PWR / MENU
button twice to go directly to the normal
operating mode.
Note:
Pressing the
PWR / MENU
button before pressing the
ENTER
button will cancel that configuration change.
Note:
If the
PWR / MENU
button is held too long the meter will display all 8’s and the meter will
turn off.
4.2.2
Entering Tare Weight For A Typical Short Logger System
Weigh the entire empty truck with full fuel tanks and driver (both front and rear axles) using a
certified platform scale. This is the truck’s Tare weight. Enter this number in the space provided. For
the Net Payload weight method the Tare weight must be set to zero.
Tare weight of entire empty truck:
(Ch A)
Divide the empty truck weight by 2 and enter in the space provided.
Tare Weight of entire empty truck divided by 2:
(Ch B)
Weigh the front axle group of the empty trailer.
Tare Weight of front axle group of the empty trailer:
(Ch C)
Weigh the rear axle group of the empty trailer.
Tare Weight of rear axle group of the empty trailer:
(Ch D)
Procedure To Enter Tare Weights For A Typical Short Logger System:
Stop the empty truck and trailer on level ground.
Enter the
SETUP / CALIBRATE
Menu, (Section 3.3).
Press the
CYCLE
button until
SET: TARE WEIGHT
is displayed.
Press the
ENTER
button to select the
SET: TARE WEIGHT
option.
June 21, 2006
VULCAN ON-BOARD SCALES 1-800-237-0022
Doc. 44-10032-001 Rev. C
©
STRESS-TEK, INC. 2006