CHAPTER 4
65
Enter the
SETUP / CALIBRATION
Menu, (Section 3.3).
Press the
CYCLE
button until
SET: TARE WEIGHT
is displayed.
Press the
ENTER
button to select the
SET: TARE WEIGHT
option.
Press either the
UP or DOWN ARROW
buttons to adjust the number to the desired
Tare Weight.
Note: If The Tare Number, Channel, And Weight Indicators Are Flashing:
The Lock option is
activated. The
UP
and
DOWN ARROW
buttons have no effect. Refer to Section 3.2.10 to
deactivate the Lock feature.
Press the
CYCLE
button to advance to the next channel. The meter will now ask to save
<YES>
or
<NO>
.
Press either
UP
or
DOWN
ARROW
buttons to change to either the
YES
or the
NO
selection. If
YES
is selected, the meter
will
store the new Tare Weight. If
NO
is
selected,
the
meter
will not
store the new Tare Weight.
Press the
ENTER
button to enter the
YES
or
NO
selection. The meter will now display the
next designated channel to set the Tare Weight.
Note:
If the
ENTER
button is pressed after adjusting the Tare Weight and before pressing the
CYCLE
button, the adjusted Tare Weight for that particular channel will be stored and the meter will
return to the
SET: TARE WEIGHT
Menu option.
Repeat the previous steps until each active channel, up to 6 channels, has the Tare Weight set.
Once the last Tare Weight has been adjusted, press the
ENTER
button to save the new Tare
Weight and return to the
SET: TARE WEIGHT
Menu option.
June 21, 2006
VULCAN ON-BOARD SCALES 1-800-237-0022
Doc. 44-10032-001 Rev. C
©
STRESS-TEK, INC. 2006