14
CHAPTER 1
Figure 1-J VSL Vulcoder Communication Connection
8.
Once all of the Vulcoders have been installed, the Vulcoders must have either the wire loop cut
or uncut. Cutting the loop wire will designate the Vulcoder as a
Front
Vulcoder (refer to
Figure 1-K) and not cutting the Vulcoder designates the Vulcoder as a
Rear
Vulcoder (refer to
Figure 1-L). Following this procedure will enable the meter to properly assign channels.
For example
, on a 2-channel system with the truck having a
Front
Vulcoder, and the trailer
having a
Rear
Vulcoder, the meter will sequence the Front Vulcoder as Channel A, and the
Rear Vulcoder as Channel B.
CUT
ORANGE
CABLE
BLACK
CABLE
LOAD CELL
LOAD CELL
Figure 1-K
Front
VSL Vulcoder Configuration
June 21, 2006
VULCAN ON-BOARD SCALES 1-800-237-0022
Doc. 44-10032-001 Rev. C
©
STRESS-TEK, INC. 2006
